CARBON STEEL AND STAINLESS STEEL END PLATES

  

The production of convex end plates is divided into cold-drawn end plates (with diameters from 900 mm to 3000 mm and thicknesses from 2.5 to 12 mm) and pressed end plates (with diameters from 350 mm to 1270 mm and minimum thickness  mm 1 and maximum  mm 4). In the technical card the former are identified by the letter “F” , while the pressed end plates are of autoclave and/or first-spill tank type, a distinction that must always be quoted when ordering.

Attachment :Pressed bases for general purpose water tanks
Attachment :Pressed bases autoclave- type
Attachment :Cold drawn type "F"  


TECHNICAL NOTES
The materials worked have a max. breaking strain of 48/50 Kg and a minimum elongation of 22/24%.
For end plates machined from welded discs or for which an X-ray check of the welds is planned after forming, these latter will only be subject to testing if explicitly requested.
The company also provides a subcontract machining service. In this case it is recommended to contact our technical office before cutting the discs and/or rectangles for further confirmation of developments or for anything else needed for machining requirements.
Lo Cascio Salvatore & C. srl is entitled to use the ISO 9001-2000 mark.